4" Dome Installation Instructions
Once the 4’’ wetware is plumbed into the manifold, here’s how to install the dome on top:
Remove the cap and gasket from the center of the dome
Power on the dome by pressing the power button on the underside of the device. The LEDs will flash white and then blink as it searches for the network
Position the dome over the top of the wetware, aligning the center hole over the spring tension shaft and the gap in the dome over the upper chamber outlet
Gently push the dome onto the top of the valve so that pegs on the underside of the dome align with the mouth of each metal dome clip on the valve body
Rotate the dome clockwise until the dome clips ‘click’ and the dome is securely in place
Reinsert the gasket in the center of the dome
Replace the cap by pushing it into the center of the dome until it’s flush and snaps in place
Place the 4-pronged green handle on top of the spring tension shaft by aligning the rectangular insert and pushing down
Insert the bleed needle through the center of the handle into the spring tension shaft, and gently finger tighten
Connect the lower chamber tube to the lower chamber port on the dome, finger tighten the nut
Connect the upper chamber tube to the upper chamber port on the dome, finger tighten the nut
Connect the antenna, solar panel/power supply, flow meter cable, and any auxiliary sensors
Completed Dome Installation